Preparation and Use of ADIFAB2

 

When you receive your order of ADIFAB2, do the next three steps IMMEDIATELY :

1. FREEZE (at -70°C if possible) LYOPHOLIZED ADIFAB2
2. FREEZE (at -20°C) STANDARD(S)
3. REFRIGERATE (at 4°C) STORAGE AND MEASURING BUFFERS

Preparation of ADIFAB2 stock solution:

Add storage buffer to the vial of lyophilized ADIFAB2 powder to give a final concentration of ~100 µM. The approximate molecular weight of ADIFAB2 is 15000 g/mole; therefore, for every 200 µg ADIFAB2, add 133 µL storage buffer and for 1 mg ADIFAB2, add 667 µL. Once storage buffer is added to ADIFAB2, store at 4°C. The storage buffer consists of 20 mM HEPES, 140 mM NaCl, 5 mM KCL, 1 mM Na2HPO4, 1 mM EDTA and 0.05% sodium azide. The pH at room temperature is 7.4 ± 0.1.

Measuring Buffer:

Measuring buffer consists of 20 mM HEPES, 140 mM NaCl, 5 mM KCl, and 1 mM Na2HPO4. The pH at room temperature equals 7.4 ± 0.1. Store the measuring buffer at 4ºC. The recommended concentration of ADIFAB2 to be used in the measuring buffer is approximately 0.5 µM. The concentration can be increased or decreased depending on the efficiency of the fluorometer used.

Cuvettes:

Cuvettes made of glass or quartz are recommended for the measurement of ADIFAB2. These cuvettes must be very clean and all traces of soap rinsed away. A final rinse of ethanol and then drying under a nitrogen stream is recommended. Disposable cuvettes can also be used. Plastic cuvettes made of polystyrene from Sarstedt (cat# 67.754) have been found to work well with the ADIFAB2 probe. However acrylic cuvettes have been found to leach a substance that reacts with the probe. Cuvettes made of other materials can be easily tested by determining if the ADIFAB2 ratio changes over time.